Project

General

Profile

U-boot not bringing Linux kernel up correctly » built_preloader_uboot.txt

Chris Weinman, 01/22/2015 01:58 AM

 
1
BOARD : Altera SOCFPGA Cyclone V Board
2
CLOCK: EOSC1 clock 25000 KHz
3
CLOCK: EOSC2 clock 25000 KHz
4
CLOCK: F2S_SDR_REF clock 0 KHz
5
CLOCK: F2S_PER_REF clock 0 KHz
6
CLOCK: MPU clock 800 MHz
7
CLOCK: DDR clock 400 MHz
8
CLOCK: UART clock 100000 KHz
9
CLOCK: MMC clock 50000 KHz
10
CLOCK: QSPI clock 400000 KHz
11
RESET: COLD
12
INFO : Watchdog enabled
13
SDRAM: Initializing MMR registers
14
SDRAM: Calibrating PHY
15
SEQ.C: Preparing to start memory calibration
16
SEQ.C: CALIBRATION PASSED
17
SDRAM: 1024 MiB
18
SDRAM: ECC Enabled
19
SF: Read data capture delay calibrated to 3 (0 - 6)
20
SF: Detected N25Q128A with page size 65536, total: 16777216
21

    
22

    
23
U-Boot 2013.01.01 (Jan 21 2015 - 21:08:49) Critical Link MitySOM-5CSx
24

    
25
CPU   : Altera SOCFPGA Platform
26
BOARD : Critical Link MitySOM-5CSx Module
27
I2C:   ready
28
DRAM:  1 GiB
29
MMC:   ALTERA DWMMC: 0
30
SF: Read data capture delay calibrated to 7 (0 - 15)
31
SF: Detected N25Q128A with page size 65536, total: 16777216
32
In:    serial
33
Out:   serial
34
Err:   serial
35
Net:   mii0
36

    
37
preboot reading MMC uBoot ENV data
38

    
39
** File not found /etc/uBootStatic.env **
40
## Info: input data size = 1589 = 0x635
41
** File not found /etc/uBoot.env **
42
## Info: input data size = 1589 = 0x635
43
...done
44
Hit any key to stop autoboot:  0
45
gpio: pin 28 (bank/mask = 0/0x10000000)
46
gpio: pin 28 (gpio 28) value is 0
47
gpio: pin 28 (bank/mask = 0/0x10000000)
48
gpio: pin 28 (gpio 28) value is 1
49
gpio: pin 0 (bank/mask = 0/0x00000001)
50
gpio: pin 0 (gpio 0) value is 1
51
gpio: pin 9 (bank/mask = 0/0x00000200)
52
gpio: pin 9 (gpio 9) value is 0
53
gpio: pin 9 (bank/mask = 0/0x00000200)
54
gpio: pin 9 (gpio 9) value is 1
55
7007184 bytes read in 361 ms (18.5 MiB/s)
56
## Starting application at 0x3FF78548 ...
57
## Application terminated, rc = 0x0
58
3495680 bytes read in 182 ms (18.3 MiB/s)
59
18391 bytes read in 16 ms (1.1 MiB/s)
60
## Booting kernel from Legacy Image at 00007fc0 ...
61
   Image Name:   Linux-3.12.0-g456859b
62
   Image Type:   ARM Linux Kernel Image (uncompressed)
63
   Data Size:    3495616 Bytes = 3.3 MiB
64
   Load Address: 00008000
65
   Entry Point:  00008000
66
## Flattened Device Tree blob at 00000100
67
   Booting using the fdt blob at 0x00000100
68
   XIP Kernel Image ... OK
69
OK
70
   Loading Device Tree to 03ff8000, end 03fff7d6 ... OK
71

    
72
Starting kernel ...
73

    
74
Uncompressing Linux... done, booting the kernel.
75
Booting Linux on physical CPU 0x0
76
Initializing cgroup subsys cpuset
77
Linux version 3.12.0-g456859b (user@MitySOM-Dev) (gcc version 4.8.1 (GCC) ) #2 SMP Mon Jan 19 02:25:13 EST 2015
78
CPU: ARMv7 Processor [413fc090] revision 0 (ARMv7), cr=10c5387d
79
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
80
Machine: Altera SOCFPGA, model: MitySOM-5CSX Altera SOCFPGA Cyclone V
81
bootconsole [earlycon0] enabled
82
Memory policy: ECC disabled, Data cache writealloc
83
Early printk initialized
84
PERCPU: Embedded 8 pages/cpu @80b80000 s11328 r8192 d13248 u32768
85
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 130048
86
Kernel command line: console=ttyS0,115200 root=/dev/mmcblk0p2 rw rootwait mem=512M earlyprintk=serial,ttyS0,115200
87
PID hash table entries: 2048 (order: 1, 8192 bytes)
88
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
89
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
90
Memory: 512008K/524288K available (5266K kernel code, 261K rwdata, 1472K rodata, 347K init, 247K bss, 12280K reserved)
91
Virtual kernel memory layout:
92
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
93
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
94
    vmalloc : 0xa0800000 - 0xff000000   (1512 MB)
95
    lowmem  : 0x80000000 - 0xa0000000   ( 512 MB)
96
    modules : 0x7f000000 - 0x80000000   (  16 MB)
97
      .text : 0x80008000 - 0x8069cba4   (6739 kB)
98
      .init : 0x8069d000 - 0x806f3c40   ( 348 kB)
99
      .data : 0x806f4000 - 0x80735650   ( 262 kB)
100
       .bss : 0x80735650 - 0x80773384   ( 248 kB)
101
SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=2, Nodes=1
102
Hierarchical RCU implementation.
103
NR_IRQS:16 nr_irqs:16 16
104
sched_clock: 32 bits at 100MHz, resolution 10ns, wraps every 42949ms
105
Console: colour dummy device 80x30
106
Calibrating delay loop... 1594.16 BogoMIPS (lpj=7970816)
107
pid_max: default: 32768 minimum: 301
108
Mount-cache hash table entries: 512
109
CPU: Testing write buffer coherency: ok
110
ftrace: allocating 17987 entries in 53 pages
111
CPU0: thread -1, cpu 0, socket 0, mpidr 80000000
112
Setting up static identity map for 0x804c16c8 - 0x804c1720
113
CPU1: failed to come online
114
Brought up 1 CPUs
115
SMP: Total of 1 processors activated.
116
CPU: All CPU(s) started in SVC mode.
117
devtmpfs: initialized
118
VFP support v0.3: implementor 41 architecture 3 part 30 variant 9 rev 4
119
NET: Registered protocol family 16
120
fpga bridge driver
121
DMA: preallocated 256 KiB pool for atomic coherent allocations
(1-1/2) Go to top
Add picture from clipboard (Maximum size: 1 GB)