U-Boot SPL 2013.10-00050-ged374e1-dirty (Aug 25 2015 - 17:25:28) MitySOM335x profile 1 - Model No: 3354-HX-X38-RC Serial No: 137410 Configuring for 512 MB DDR3 @ 400MHz Critical Link AM335X Dev Kit -- NAND Page size = 4096k booting from dev 5 Using 4k bch16 layout ECC Mode = 2 lo = 208/0 nand_spl_load_image: loading 4096 bytes from 100000 to 80800000 nand_spl_load_image: loading 458116 bytes from 100000 to 807fffc0 U-Boot 2013.10-00050-ged374e1-dirty (Aug 25 2015 - 17:25:28) AM335X-GP rev 2 I2C: ready DRAM: 512 MiB WARNING: Caches not enabled NAND: Using 4k bch16 layout ECC Mode = 2 lo = 208/0 512 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 Net: cpsw:2 is connected to cpsw. Reconnecting to cpsw cpsw Hit any key to stop autoboot: 0 U-Boot# print ipaddr ## Error: "ipaddr" not defined U-Boot# setenv ipaddr 10.0.102.41 U-Boot# setenv netmask 255.0.0.0 U-Boot# mw.b 0x82000000 ff 4000 U-Boot# tftp 0x82000000 10.0.62.1:MLO link up on port 0, speed 1000, full duplex link up on port 1, speed 1000, full duplex *** ERROR: `serverip' not set U-Boot# setenv serverip 10.0.62.1 U-Boot# tftp 0x82000000 10.0.62.1:MLO link up on port 0, speed 1000, full duplex link up on port 1, speed 1000, full duplex Using cpsw device TFTP from server 10.0.62.1; our IP address is 10.0.102.41 Filename 'MLO'. Load address: 0x82000000 Loading: ##### 1.9 MiB/s done Bytes transferred = 60652 (ecec hex) U-Boot# nand erase 0x0 0x100000 NAND erase: device 0 offset 0x0, size 0x100000 Erasing at 0xc0000 -- 100% complete. OK U-Boot# nand write.i 0x82000000 0x0 $filesize NAND write: device 0 offset 0x0, size 0xecec 60652 bytes written: OK U-Boot# nand write.i 0x82000000 0x40000 $filesize NAND write: device 0 offset 0x40000, size 0xecec 60652 bytes written: OK U-Boot# nand write.i 0x82000000 0x80000 $filesize NAND write: device 0 offset 0x80000, size 0xecec 60652 bytes written: OK U-Boot# nand write.i 0x82000000 0xc0000 $filesize NAND write: device 0 offset 0xc0000, size 0xecec 60652 bytes written: OK U-Boot# mw.b 0x82000000 ff 200000 U-Boot# tftp 0x82000000 10.0.62.1:u-boot.img link up on port 0, speed 1000, full duplex link up on port 1, speed 1000, full duplex Using cpsw device TFTP from server 10.0.62.1; our IP address is 10.0.102.41 Filename 'u-boot.img'. Load address: 0x82000000 Loading: ################################ 2 MiB/s done Bytes transferred = 458112 (6fd80 hex) U-Boot# nand erase 0x100000 0x200000 NAND erase: device 0 offset 0x100000, size 0x200000 Erasing at 0x2c0000 -- 100% complete. OK U-Boot# nand write.i 0x82000000 0x100000 $filesize NAND write: device 0 offset 0x100000, size 0x6fd80 458112 bytes written: OK U-Boot# reset resetting ... U-Boot SPL 2013.10-00051-g8c06fad (Sep 03 2015 - 09:40:56) MitySOM335x profile 1 - Model No: 3354-HX-X38-RC Serial No: 137410 Configuring for 512 MB DDR3 @ 400MHz Critical Link AM335X Dev Kit -- NAND Page size = 4096k booting from dev 5 Using 4k bch16 layout ECC Mode = 2 lo = 208/0 nand_spl_load_image: loading 4096 bytes from 100000 to 80800000 nand_spl_load_image: loading 458112 bytes from 100000 to 807fffc0 U-Boot 2013.10-00051-g8c06fad (Sep 03 2015 - 09:40:56) AM335X-GP rev 2 I2C: ready DRAM: 512 MiB WARNING: Caches not enabled NAND: Using 4k bch16 layout ECC Mode = 2 lo = 208/0 512 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 Net: cpsw:2 is connected to cpsw. Reconnecting to cpsw cpsw Hit any key to stop autoboot: 0 U-Boot#