Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

09/26/2018

01:55 PM Software Development: RE: kernel panic on virtual machine start

I'm afraid the answer is probably to create a new ubuntu VM from scratch and then (after removing the image from any ... Tim Iskander

11:26 AM Software Development: RE: kernel panic on virtual machine start

Hello Tim,
I also tried to add hard disk option in new VM for old .vmdk file . Then I tried to mount that in VM. b... Vivek Ponnani

10:24 AM Software Development: RE: kernel panic on virtual machine start

Thanks Tim for your reply. As per your suggestion it seems I must have VM setup where it failed. But unfortunately, I... Vivek Ponnani

09/24/2018

11:30 AM Software Development: RE: kernel panic on virtual machine start

Vivek
Your best bet is the following:
Rename the existing VM
Re-import the VM from the ova image
Go in to setting... Tim Iskander

09/23/2018

09:06 AM Software Development: kernel panic on virtual machine start

Hi,
I had setup of virtual machine with Critical_Link_Unified_VM_14-04_04-2017.ova image. Something went wrong with ... Vivek Ponnani

09/14/2018

01:32 PM Software Development: RE: Yocto MDK Status

Thanks Tom. Jonathan Cormier

12:40 AM Software Development: RE: Yocto MDK Status

FYI... have made the following changes to the recipes as to update fetching the proper sources. For vim it's a differ... Tom Riddle

08/29/2018

11:06 PM Software Development: RE: Yocto MDK Status

Hi, well it was easier then trying to fix the two repo failures, (which I will do)... just running bitbake again with... Tom Riddle

10:04 PM Software Development: RE: Yocto MDK Status

Tom Riddle wrote:
> Hi Jonathan,
>
> We open a shell, go to yocto-archives dir, set the env
>
> > source oe-i... Jonathan Cormier

07:36 PM Software Development: RE: Yocto MDK Status

Hi Jonathan,
We open a shell, go to yocto-archives dir, set the env
> source oe-init-build-env
then execute... Tom Riddle

08/28/2018

06:21 PM Software Development: RE: Yocto MDK Status

Could you provide a log of your bitbake command plus output in an attached file? Jonathan Cormier

06:10 PM Software Development: RE: Yocto MDK Status

Hi Folks... any feedback on where the image might be? Thanks, Tom Tom Riddle

03:18 PM PCB Development: RE: OMAP L138 HPI

Unfortunately during my initial review of the modules with and without FPGA I confused the RESETOUT (T17) pin connect... Alexander Block

09:05 AM PCB Development: RE: OMAP L138 HPI

Thank you.
I was able to check the connection information between FPGA and L138.
Could you tell me the pin wiri... Hisato Seki