Activity
From 10/16/2023 to 11/14/2023
11/10/2023
- 06:20 PM PCB Development: RE: Munti-function OMAP pins
- Note if you developing a custom baseboard, I'd recommend sending it to support@criticallink.com to have it reviewed.
... - 06:18 PM PCB Development: RE: Munti-function OMAP pins
- Any gpio can be used as a spi chip select.
Examples:
https://support.criticallink.com/gitweb/?p=linux-davinci.git... - Hello,
I would like to use the SPI1 on the OMAP with two separate devices are the pin functions in the critical li...
11/06/2023
- 06:22 PM PCB Development: RE: MityDSP-L138F Boot issue, I2C0 (PCB Dev Post)
- Jon Cox wrote in message#6539:
> Jonathan,
>
> Thanks for taking a look at the logs.
>
> This is an issue we h... - 03:36 PM PCB Development: RE: MityDSP-L138F Boot issue, I2C0 (PCB Dev Post)
- Jonathan,
Thanks for taking a look at the logs.
This is an issue we have been having in parallel to the I2C iss... - 02:50 PM PCB Development: RE: MityDSP-L138F Boot issue, I2C0 (PCB Dev Post)
- Jon Cox wrote in message#6537:
> Jonathan,
>
> Apologies on the delay, we've had most of the systems tied up in-u...
11/03/2023
- 04:15 PM PCB Development: RE: MityDSP-L138F Boot issue, I2C0 (PCB Dev Post)
- Jonathan,
Apologies on the delay, we've had most of the systems tied up in-use for the past few weeks but I was ab...
10/23/2023
- 02:06 PM PCB Development: RE: MityDSP-L138F Boot issue, I2C0 (PCB Dev Post)
- Any updates?
Also available in: Atom
Go to top