Mity CPU Platforms » ARM9 Based QNX Platforms

06/29/2011

04:44 PM Software Development: RE: 1st time boot up

Mark,
A new BSP has been posted. The serial port driver has been changed so that with a -M option, it will not ena... John Pruitt

03:08 PM Software Development: RE: 1st time boot up

Great, thanks.
FWIW I've verified USB and Ethernet works fine. I can comment out all the ports and run from the ser... Mark Lyon

03:04 PM Software Development: RE: 1st time boot up

Mark,
It has been a little while and I wanted you to know that we have reproduced this problem and are working on ... John Pruitt

06/28/2011

12:25 PM Software Development: RE: OMAP I2C

Rob,
The two utilities are convenient for easy command-line or script-based access to the I2C for simple control f... John Pruitt

12:11 PM Software Development: OMAP I2C

Hello,
The MityDSP QNX BSP starts up the IC2 QNX driver, but also has two utilities (i2c_get, i2c_set) that bypass... Rob Gillis

06/27/2011

01:58 PM Software Development: RE: 1st time boot up

...one more thing... Linux boots up fine, and reports:... Mark Lyon

01:54 PM Software Development: RE: 1st time boot up

I am currently running an unmodified boot script, the above section matches.
A log message immediately after
<p... Mark Lyon

12:02 PM Software Development: RE: 1st time boot up

If you are seeing the Welcome banner, you should be through the start-up code and into the qnx kernel. By default, th... John Pruitt

11:45 AM Software Development: RE: 1st time boot up

Wow - thanks for the fast reply.
I do want to use UART0, I was just trying that to see if it was the problem.
I a... Mark Lyon

11:35 AM Software Development: RE: 1st time boot up

Mark,
Which board are you using?
Are both uart0 and uart1 available?
Is u-boot using uart0?
Did you change t... John Pruitt

11:27 AM Software Development: 1st time boot up

I have followed the directions in the Wiki for booting up the MityDSP board, and I get as far as the banner before ev... Mark Lyon