Project

General

Profile

Activity

From 04/27/2015 to 05/26/2015

05/26/2015

03:54 AM FPGA Development: HSMC1 pinout
Hi,
I am using the "mityarm_5csx_dev_board_hsmc_setup.tcl":https://support.criticallink.com/redmine/boards/47/topi...
Florian Rieger

05/20/2015

08:22 AM Software Development: PHY not working with QSPI flash boot
Hi,
I am trying to set up the MitySOM such that U-Boot is stored on the flash memory and the Linux Kernel, DTS and...
Alexandre Lopes

05/19/2015

03:30 AM Software Development: RE: Boot configuration jumpers
Thank you very much. As I've seen the labeling is to the right of the switch (in my case), hence I didn't pay attenti... Alexandre Lopes

05/18/2015

11:30 AM Software Development: RE: Boot configuration jumpers
Sorry this isn't clear. There is silkscreen labeling below the switch corresponding to the switch locations 1-10: MS... Adam Dziedzic
11:05 AM Software Development: Boot configuration jumpers
Hi,
Can someone please shed me some light on the boot configuration jumpers of the MitySOM-5CSX Dev-Kit? On the da...
Alexandre Lopes

04/30/2015

07:53 AM Software Development: RE: Bare-metal interrupt handling working only in debugger
Hi Alex,
Glad you solved your issue, sorry we didn't provide much help. We don't have a lot of folks trying to do...
Michael Williamson
06:22 AM Software Development: RE: Bare-metal interrupt handling working only in debugger
No, that was obviously not the reason. The unhosted and hosted linker scripts do link against different libraries but... Alexandre Lopes

04/28/2015

03:50 PM Software Development: RE: Bare-metal interrupt handling working only in debugger
I am now thinking that I might have to use the unhosted version of the linker script (even though it worked just fine... Alexandre Lopes
02:36 PM Software Development: RE: Bare-metal interrupt handling working only in debugger
Hi Mike,
That address is indeed the base of the interrupt table. I have been using it without any problem with oth...
Alexandre Lopes
11:20 AM Software Development: RE: Bare-metal interrupt handling working only in debugger
I personally haven't tried to do this before, but isn't address 0x30000000 the base of your interrupt vector table? ... Michael Williamson
11:10 AM Software Development: Bare-metal interrupt handling working only in debugger
Hello,
I am using the MitySOM Dev Kit and I want to use interrupts in a bare-metal
application. To that effect I...
Alexandre Lopes
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)