Mity CPU Platforms » MitySOM-5CSX Altera Cyclone V

11/18/2015

AD 12:54 PM FPGA Development: RE: JTAG: No JTAG hardware available

Hi Darius,
To start, I'm not sure what your hardware setup is, so I will assume you are working with a Dev Board or a board that can boot from an SD Card. When that boots, there is a very brief preloader configuration, then uBoot sta... Adam Dziedzic

DB 11:19 AM FPGA Development: RE: JTAG: No JTAG hardware available

Adam,
Thank you for your reply. How would I need to go about configuring the flash via the console USB connector?
Darius Darius Bethel

11/10/2015

AD 01:24 PM FPGA Development: RE: JTAG: No JTAG hardware available

Hi Darius,
The console USB connector is simply a UART interface. You can use this to talk to uBoot and the Linux console to configure the flash. If you want to go through JTAG, the white connector on the top of the MitySOM will acce... Adam Dziedzic

DB 11:42 AM FPGA Development: JTAG: No JTAG hardware available

Hello all,
I am trying to to program QSPI using the hps programmer tool , via the j400 console usb, within the virtual box environment. Using jtagconfig in the Altera Embedded Command Shell, I receive a message that says, No JTAG hard... Darius Bethel