Project

General

Profile

Activity

From 06/02/2017 to 07/01/2017

06/20/2017

05:59 PM FPGA Development: RE: Power fail interrup
Clyde,
Offhand our recommendation would be to utilize an HPS GPIO and have it configured in the GPIO controller as...
Alexander Block
05:14 PM FPGA Development: RE: Power fail interrupt
What more is there to say, really? We have a low voltage supervisor in our design and when the power is going to fai... Clyde Shappee
04:45 PM FPGA Development: RE: Power fail interrup
Hello Clyde,
Could you describe the situation a bit more?
Thanks!
Dan
Daniel Vincelette
02:05 PM FPGA Development: Power fail interrup
What is the recommended input to the SOM for a power fail interrupt?
clyde
Clyde Shappee

06/14/2017

09:10 PM PCB Development: VCCPGM and VCCBAT
Hello, I have a 5CSX-H6-4YA-RI board.
What do I pull the MSEL lines up to when I pull them up.
(what is VCCPGM p...
Craig Drennan

06/07/2017

02:20 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
Hello Mike and Adam,
I very much appreciate you both providing other suggestions readily available with our MitySO...
Jared Kirschner

06/02/2017

12:14 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
The QSPI NOR is supported by the MTD layer, so you should be able to partition it and mount it using JFFS2 (or perhap... Michael Williamson
12:05 PM Software Development: RE: Using EEPROM available on MitySOM-5CSX
We're using the 5CSX-H6-4YA so we should have 32MB of QSPI NOR, and we are booting from SD card, though it's possible... Stephen Snyder
10:25 AM Software Development: RE: Using EEPROM available on MitySOM-5CSX
Hi Jared,
If you are looking for a small amount of space, there is also some memory available in the RTC. There i...
Adam Dziedzic
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)