Project

General

Profile

Activity

From 10/30/2023 to 11/28/2023

11/21/2023

04:59 PM PCB Development: RE: Pin connection
Hello Dan,
Thanks for providing this information and support. According to this datasheet, the FPGA module has an...
Mohammad Hassan Adeli

11/20/2023

06:30 PM PCB Development: RE: Pin connection
Hello Mohammad,
Please take a look at our development board schematic, if you haven't already. It can be found her...
Daniel Vincelette

11/17/2023

07:38 PM PCB Development: RE: Pin connection
Thanks for your reply, Mike. I used Y13 as the clock pin in the development board and I wonder where internally in th... Mohammad Hassan Adeli
07:30 PM PCB Development: RE: Pin connection
Hi Mohammad,
If you open up the Datasheet and check Table 8 and search for Y13 you should that it is a direct conn...
Michael Williamson
07:08 PM PCB Development: Pin connection
Hello,
I have a development kit of MitySOM-5csx (https://www.criticallink.com/product/mitysom-5csx-dev-kit/). I w...
Mohammad Hassan Adeli

11/16/2023

06:18 PM MitySOM-5CSX Embedded Vision Developer's Kit for Basler dart BCON Support: RE: Barrel jack type
Marko,
The manufacturer part number used for the barrel jack is PJ-059BH. I have attached the manufacturer datashe...
Alexander Block
07:28 AM MitySOM-5CSX Embedded Vision Developer's Kit for Basler dart BCON Support: Barrel jack type
Hello,
I was wondering if you could help me find information on the specifications for the barrel plug, we need t...
Marko Mamić
03:02 PM FPGA Development: Clock frequency pins
Hello,
We have this module (https://www.criticallink.com/product/mitysom-5csx/ ) board on our project board and al...
Mohammad Hassan Adeli

11/02/2023

02:35 AM PCB Development: RE: MSEL[4] and return current cap...
Sorry if I wasn't clear. The caps are optional. They might help in a worst case situation, but for most designs the... David Rice

11/01/2023

11:34 PM PCB Development: RE: MSEL[4] and return current cap...
Hi David,
I understand that, but the eval board only has them on MSEL[3:0] and does not have one on MSEL[4].  So, ...
Austin Franklin
07:38 PM PCB Development: RE: MSEL[4] and return current cap...
The intention of the caps to ground on these signals is to allow some high frequency ground currents from the SOM I/O... David Rice
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)