Mity CPU Platforms

07/07/2023

03:33 PM MitySOM-5CSX Altera Cyclone V Software Development: How do I use ARM FVP or any other virtualization?

Hello,
Our application is MitySOM-5CSx based. We are trying to use FVP or QEMU for simulation during firmware deve... Saumil Patel

06/27/2023

06:13 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Project files and Quartus startup

Eric,
https://www.intel.com/content/www/us/en/products/details/fpga/development-tools/quartus-prime/resource.html
... Mike Fiorenza

05:43 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Project files and Quartus startup

Thanks Mike.
That page filled in a couple of knowledge gaps for me.
I'm still struggling to find out where to g... Eric Nelson

03:41 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Project files and Quartus startup

Eric,
https://support.criticallink.com/redmine/projects/mityarm-5cs/wiki/Building_fpga_181
This should be the b... Mike Fiorenza

05:35 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Pin-muxing SPI

Eric,
Thanks for sharing! I wasn't sure if it supported arbitrary GPIO pins or not. Good to know!
- Mike Mike Fiorenza

05:33 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Pin-muxing SPI

Thanks Mike.
In case it's useful to someone else, I saw that the driver supports the use of "arbitrary GPIO pins":... Eric Nelson

03:36 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Pin-muxing SPI

Hi Eric,
Your assumptions are correct. To use the hard HPS SPI peripheral, you would use the signals you have high... Mike Fiorenza

05:27 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Toolchain bundles

Thanks Mike Eric Nelson

03:43 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Toolchain bundles

Eric,
Use poky-glibc-x86_64-mitysom-image-base-cortexa9hf-neon-toolchain-2.4.4.sh which is under the Quartus 18.1 ... Mike Fiorenza

06/26/2023

09:51 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Project files and Quartus startup

I'm also answering my first question (how to launch Quartus).
The executable name is quartus, and it seems that I ... Eric Nelson

04:01 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Project files and Quartus startup

I found the answer to the second question on this page:
https://support.criticallink.com/redmine/projects/mityarm-... Eric Nelson

03:51 PM MitySOM-5CSX Altera Cyclone V Software Development: Project files and Quartus startup

I'm just getting started with a MitySOM-5CSX and
First off, this page says "launch quartus", and I'm not sure how... Eric Nelson

03:53 PM MitySOM-5CSX Altera Cyclone V Software Development: Toolchain bundles

There are three poky toolchain bundles on this page, and two of them have the same name, "poky-eglibc-x86_64-mitysom-... Eric Nelson

06/23/2023

11:54 PM MitySOM-5CSX Altera Cyclone V Software Development: Pin-muxing SPI

Hi all,
We'd like to make use of the SPI peripheral on the MitySOM-5CSx with at least two different chip-selects.
... Eric Nelson

08:07 PM MitySOM-AM57X PCB Development: RE: Unconnected pins, board dimensions and hole positions

Hello.
1. Generally speaking, all of the MFIO pins are direct connects to the AM57xx CPU device and if they are un... Michael Williamson

06:51 PM MitySOM-AM57X PCB Development: Unconnected pins, board dimensions and hole positions

Posting on behalf of customer:
1.The J1 and J3 connectors of MitySOM-AM57 are described as “MFIO” for “Type”.
... Thomas Catalino

06/14/2023

02:46 PM MitySOM-AM57X PCB Development: RE: Design support for USB for use with AM57x SOM

Datasheet has been released Jonathan Cormier

06/09/2023

04:53 PM MitySOM-AM57X PCB Development: RE: Design support for DP83640 Phy IC for use with AM57x SOM

Hi,
For testing IEEE 1588 H/W time stamp application, we included DP83640 in our circuit. Since DP83640 doesn't ha... Sandeep Sivadas