Activity
From 06/05/2026 to 07/04/2026
06/26/2026
- 09:33 PM MitySOM-5CSX Altera Cyclone V Software Development: RE: Using GPIO command on UBoot command line...is there any pin mapping between HPS pin # and GPIO pin #?
- From Dan at CL (Thanks Dan!)
Our reference project has the following HPS IO set as GPIO:
- GPIO40 — edge pin 264 ...
06/25/2026
- Hi,
I have the CriticalLink UBoot image on a terminal program. There is the GPIO set/clear/toggle command. It wa...
06/24/2026
- 03:38 PM MitySOM-5CSX Altera Cyclone V PCB Development: RE: LED on nCONFIG...
- Hi Mike,
Thank you for the confirmation. I've attached a picture of my proposed update to our MitySOM boards. An... - 02:21 PM MitySOM-5CSX Altera Cyclone V PCB Development: RE: LED on nCONFIG...
- Hi Austin,
You are correct that the Cyclone V cannot drive this pin. It is a configuration control input which mus...
06/23/2026
- On the CriticalLink MitySOM-5CSX development board, there is an LED D100 connected to nCONFIG (pin 39). According to...
06/12/2026
- 07:00 PM MitySOM-A5 Software Development: RE: make_sd.sh doesn't take command line parameters
- Hi Samuel,
Did you follow the instructions here and are still seeing this issue: https://support.criticallink.com/... - 06:56 PM MitySOM-A5 Software Development: RE: make_sd.sh doesn't take command line parameters
- We have tried the new DMA driver and FPGA.
We have the following situation on each reboot.
The first test pass....
06/11/2026
- 04:21 PM MitySOM-A5 Software Development: RE: make_sd.sh doesn't take command line parameters
- Max,
That is correct! And check out my latest updates to the Wiki page for it as well: https://support.criticallin... - 04:11 PM MitySOM-A5 Software Development: RE: make_sd.sh doesn't take command line parameters
- Hello Mike,
Thanks for this update.
Just to make sure, I just need to pull latest update from the following repos...
Also available in: Atom
Go to top
