Mity CPU Platforms » MitySOM-QC6490

Hi Nathan,

We used the r1.0_00095.0 release of Qualcomm_Linux.SPF.1.0|AP|Standard|OEM|NM_QIMPSDK for our firmware development. It contains the r1.0_00376 release of QCM6490.LE.1.0 where the meta-qcom-extras layer resides. These versions correspond with QC Linux 1.5.
Note that there is a limitation with QC Linux 1.5 that does not allow simultaneous streaming from more than 3 cameras, so we're migrating to a newer version in an upcoming SDK.

I have found the Linux Camera Guide - Addendum to be the most helpful document by far.

Sorry for the confusion about that link, it is only available internally. I am currently writing up a publicly available instruction document for this process. I hope to have it published tomorrow.

--

In short, you need to modify two recipes. I found using devtool (per the Camera Guide - Addendum) to be helpful.

devtool modify chicdk-kt

• Copy the existing cmk_ov9282_cam*.xml file at \${CAMX_CHICDK_PATH}/oem/qcom/module to add additional module XMLs with unique cameraId values.
• Add cmake files that correspond to these new XMLs at \${CAMX_CHICDK_PATH}/oem/qcom/buildbins/build/linuxembedded/binary_yupik/
• Modify ${CAMX_CHICDK_PATH}/oem/qcom/multicamera/chimcxcameraconfig/configs/kodiak/kodiak_dc.xml to match my desired configuration, and removed all other XMLs in this directory.
  Note in kodiak_dc.xml the slotId property must match the cameraId property from the module XML file. The cameraId value is the CSI interface number.
• Build and install chicdk-kt ipk according to the Addendum.

--

For the device tree:
devtool modify cameradtb

• open mitysom-qc6490-devkit-camera-sensor.dtsi
• Copy an existing node for the ov9281, qcom,cam-sensorX
  • X needs to match cameraId from the Module XML.
• If the new camera is going to connect to CSI0 or CSI1, paste the new node under &cam_cci0, if its CSI2-4, then it goes under &cam_cci1
• Update cell-index to match X from above.
• Update csiphy-sd-index to match CSIx number the camera will be connected to.
• Update csi-master:
  • CSI0 and CSI2 use csi-master = <0>
  • CSI1, CSI3, and CSI4 use csi-master = <1>

Let me know if you have further questions about camera development, I will update this post when I've published an official page for this process.

Thanks,
Noah

Hi Nathan,

It is posted here: https://support.criticallink.com/redmine/projects/mitysom_qc6490/wiki/Camera_Config

Please don't hesitate to reach out if you have further questions!

Thanks,
Noah