Project

General

Profile

Activity

From 04/24/2021 to 05/23/2021

05/21/2021

07:12 PM Software Development: RE: Ethernet on MitySoM
Hi Jonas,
The CSEL switches shouldn't have an effect on the ethernet interface, they are more used during the earl...
Daniel Vincelette
04:27 PM Software Development: RE: Ethernet on MitySoM
I also tried it at home now (with your image) and I can reproduce the same behavior. So it points directly towards th... Jonas Mair
03:24 PM Software Development: RE: Ethernet on MitySoM
Hi Dan,
my plan was to take the board home over the weekend to test out a different router, in the office i test...
Jonas Mair
02:37 PM Software Development: RE: Ethernet on MitySoM
Hi Jonas,
Thank you for providing the serial numbers. I've double checked our production logs and that development...
Daniel Vincelette
08:41 AM Software Development: RE: Ethernet on MitySoM
Sure,
Baseboard: 1701 8998
SoM: 1803 5616
It's an 5CSX-H6-42A-RC Module
Regards
Jonas
Jonas Mair

05/20/2021

07:57 PM Software Development: RE: Ethernet on MitySoM
Hi Jonas,
If you are also witnessing this issue with our stock SD card image then it sounds like there could be a ...
Daniel Vincelette
04:59 PM Software Development: RE: Ethernet on MitySoM
Okay an update:
Skews are set correctly, I read them out with [[ https://github.com/wkz/phytool ]] and could confi...
Jonas Mair

05/19/2021

05:23 PM Software Development: RE: Ethernet on MitySoM
Hey Dan,
I tried the device tree configurations you mentioned and also the generic ones adapted to my hardware from ...
Jonas Mair

05/17/2021

07:08 PM Software Development: RE: Ethernet on MitySoM
Hi Jonas,
Looking at the device-tree binding doc for the phy it looks like if you specify the phy address you need...
Daniel Vincelette
10:05 AM Software Development: RE: Ethernet on MitySoM
Hey Dan,
I checked the kernel configuration in menuconfig and directly in the .config of my kernel and the config ...
Jonas Mair

05/13/2021

09:19 PM Software Development: RE: USB OTG - FTDI Device problems
Hi Dan,
Thanks for the feedback. That got it working!
Travis Rawson

05/12/2021

03:15 PM Software Development: RE: Ethernet on MitySoM
Hi Jonas,
You might not have the phy driver built into your kernel, so the phy skews aren't being set. I believe t...
Daniel Vincelette
09:29 AM Software Development: RE: Ethernet on MitySoM
I apparently used the wrong gpio port, now the reset seems to be working correctly (ethtool shows a PHYAD of 3), but ... Jonas Mair

05/11/2021

12:01 PM Software Development: RE: Ethernet on MitySoM
Hey Dan,
thanks for the reply.
I created my dts with the sopc2dts tool, but appended the information given in y...
Jonas Mair

05/07/2021

08:21 PM Software Development: RE: USB OTG - FTDI Device problems
Hi Travis,
I don't believe the reference project's kernel has built in support for FTDI serial devices. Looking th...
Daniel Vincelette
07:54 PM Software Development: USB OTG - FTDI Device problems
Hello,
I am trying to connect a USB-to-RS232 dongle to the USB-OTG port on the MitySOM-5CSE-L2-3Y8 development kit...
Travis Rawson

05/05/2021

05:59 PM Software Development: RE: Ethernet on MitySoM
Hi Jonas,
From looking at your boot log it looks like the kernel incorrectly found a PHY at address 31, where it s...
Daniel Vincelette

05/04/2021

02:17 PM Software Development: Ethernet on MitySoM
Hello,
I have a MitySoM Module and the accompanying dev kit.
To use ssh and scp, i wanted to enable ethernet. For...
Jonas Mair

04/30/2021

02:01 PM FPGA Development: RE: Using Signal Tap with the L2-3Y8 dev kit
Hi Travis,
I'm sorry for the long delay, are still seeing issues with SignalTap? My normal flow for SignalTap debu...
Daniel Vincelette
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)